• State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 350 subscribers
  • Views 21851 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Arm64 Long Format Translation Table Walk

angeld

Hi all - I'm trying to understand stage 1 translation.

Assuming that the translation is starting at level 2, how do you determine the number of page table entries in the level 2 table? The documnetation says it can have up to 512 for 4kb granule size. I guess the same question goes for starting at level 1...is there a formula to finding this out?

I have a stage 1 translation that appears to have the following and I'm trying to make sense of it.

T0SZ - 38

1ea level 2 table with 32 entries
2ea level 3 tables each with 512 entries
Document reference: Arm Architecture Reference Manual Armv8, Table D5-19 Properties of the address lookup levels, 4KB granule size, page D5-2577

Parents
  • 0

    Fro the Armv8-A, each translation table descriptor uses 8-byte ( 64-bit).
    For Level 2 table of 4KB granule size,  512 entry x 8 byte = 4096 bytes = one 4K page. That's the reason you can see 512 entries for this case.

    When T0SZ=38, the valid VA bits = 64 -38 = 26.

    So Level 1 table has 5 bits. The entry number will be 2^5 = 32 entries.

Reply
  • 0

    Fro the Armv8-A, each translation table descriptor uses 8-byte ( 64-bit).
    For Level 2 table of 4KB granule size,  512 entry x 8 byte = 4096 bytes = one 4K page. That's the reason you can see 512 entries for this case.

    When T0SZ=38, the valid VA bits = 64 -38 = 26.

    So Level 1 table has 5 bits. The entry number will be 2^5 = 32 entries.

Children
No data