Hello All,
I am using Keil uVision 5. When I try to load code onto STM32F103RB Nucleo using the USB to usb mini B ST-LK,the application just closes no error message will pop up. I tried on another same Nucleo board and go the same result. I am able to build the code but unable to load it on to the Nucleo board.I tried reinstalling Keil but that didnt solve the problem
Any reasons why this might be happening and how could I go about fixing this
Thanks
As an addition, the page says: "This updated ST-Link driver file will be included in the next MDK release newer than v5.38a." I had the file in my installation folders, but it was crashing anyway. I had to replace the file that is attached on that website and it worked.